Nissan Armada 2025-2026 Service and Repair Manual: System Setting
The settings of the automatic driving positioner system can be changed, using information display in the combination meter and the set switch. Always check the settings before and after replacing driver seat control unit. For details, refer to Work Procedure.
×: Applicable
| Item | Content | Information display | Set switch | Factory setting |
|---|---|---|---|---|
| Exit assist (seat) | Exit assist (seat) can be selected: ON (operated) – OFF (not operated) | x | x | ON |
| Exit assist (steering column) | Exit assist (steering column) can be selected: ON (operated) – OFF (not operated) |
Work Procedure
Memory Storage Procedure
Two positions for the seat, steering column, and door mirror can be stored for memory operation by following procedure.
NOTE:
Memory registration can be performed with no rest ...
Work Procedure
CHOOSE METHOD
There are two ways of setting method.
Which method do you choose?
With information display>>
GO TO 2.
With set switch>>
GO TO 3.
WITH INFORMATION DISPLAY
Ignition switch ...
Other materials:
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
Exploded View
A/T assembly Hose clamp A/T water hose A A/T water hose B Clip A Clip B To water pipe. Refer to Exploded View. To oil cooling exchanger. Refer to Exploded View. : Always replace after every disassembly. ...
MULTI-WAY CONTROL VALVE : Removal & Installation
WARNING:
REMOVAL
Remove engine cover. Refer to Removal and Installation.
Remove front under cover using a power tool. Refer to Removal and Installation.
Drain engine coolant. Refer to ENGINE COOLANT : Draining.
CAUTION:
Perform this step when the engine is cold.
Remove air inlet tube 2. Refer to ...
0.005