Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure
CHOOSE METHOD
There are two ways of setting method.
Which method do you choose?
With information display>>GO TO 2.
With set switch>>GO TO 3.
WITH INFORMATION DISPLAY
Ignition switch ON.
Select "Driving Position" of “Vehicle Settings” of "Settings" of information display.
Select "Exit Seat Slide" or "Exit Steering" to change between ON and OFF.
GO TO 4.
WITH SET SWITCH
Ignition switch OFF.
Push setting button and hold for more than 10 seconds.
GO TO 4.
CONFIRM THE OPERATION
Check the exit assist function setting is changed.
>>WORK END
System Setting
The settings of the automatic driving positioner system can be changed, using information display in the combination meter and the set switch. Always check the settings before and after replacing driv ...
Other materials:
Removal and Installation
REMOVAL
CAUTION:
Remove rear evaporator. Refer to Removal and Installation.
Remove mounting bolts , and then remove rear expansion valve and rear evaporator pipe from rear evaporator.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION: ...
Work Procedure
WRITING THE REQUIRED INFORMATION FOR CONTROL UNIT REPLACEMENT
With CONSULT
Ignition switch ON.
Select "AWD/4WD".
Select "Replace ECU".
Perform the work according to the procedure displayed in CONSULT.
CAUTION:
The following conditions must be maintained during ECU modernization procedure.
Ignition s ...
Work Flow
OVERALL SEQUENCE
*1: Include 1st trip DTC. *2: Include 1st trip freeze frame data.
DETAILED FLOW
GET INFORMATION FOR SYMPTOM
Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred) using the “Diagnostic Work Sh ...
0.0051