Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure
CHECK START
In the cool LED status (wait for more than 10 minutes after turning headlamp OFF), turn ON and turn OFF headlamp for the several times. Check that headlamp operates normally each time.
In the cool LED status, turn headlamp ON, wait until headlamp enters to the stable status (approximately 5 minutes after turning headlamp ON), and then check that headlamp operates normally without blinking or flickering.
In the warm LED status (turn headlamp ON for more than 15 minutes and wait for 1 minute after turning OFF), turn ON and turn OFF headlamp for the several times. Check that headlamp operates normally each time.
Turn headlamp ON for approximately 30 minutes, and then check that headlamp operates normally without difference in brightness between LH and RH, blinking or flickering.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Refer to Symptom Table.
Other materials:
Removal and Installation
REMOVAL
Remove front door assembly. Refer to Removal and Installation.
Remove front door hinge mounting bolts, and then remove front door hinge.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
Before installation, check the front door hinge rotating ...
Perform Lubricant Return Operation
CAUTION:
If a large amount of refrigerant or lubricant leakage is detected, never perform lubricant return operation.
Start the engine and set to the following conditions.
Engine speed: Idling to 1,200 rpm
A/C switch: ON
Fan (blower) speed: Maximum speed set
Intake door position: Recirculation
Temp ...
Removal and Installation
WARNING:
REMOVAL
Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.
CAUTION:
Never depress brake pedal while brake caliper is removed.
Remove wheel sensor and harness connector. Refer to Removal and Installation.
CAUTION:
Never pull on wheel sensor harness.
Set suitable jack unde ...
0.0063