Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure

Nissan Armada 2025-2026 Service and Repair Manual / Driver Information & Multimedia / Audio, Visual & Navigation System — Around View Monitor / Basic Inspection / Work Procedure

Perform the following procedures after replacing the around view monitor control unit.

REPLACE AROUND VIEW MONITOR CONTROL UNIT

Replace around view monitor control unit. Refer to Removal and Installation.

GO TO 2.

WRITING MAC KEY

With CONSULT

Perform MAC key writing. Refer to Description.

GO TO 3.

PERFORM CONFIGURATION

With CONSULT

CAUTION:

When before writing the around view monitor control unit configuration, always writing the MAC key.

Perform "Replace ECU".

GO TO 4.

WRITING OF CALIBRATION DATA

Write the calibration data stored in the camera using CONSULT. Refer to Work Procedure.

NOTE:

When the vehicle image can be rotated by swiping in 3D View, choose "3D View Rotate" If rotation is not possible, choose "3D Fixed View."

GO TO 5.

PERFORM SELF-DIAGNOSIS

Perform the self-diagnosis of around view monitor control unit with CONSULT (AROUND VIEW MONITOR).
Check if any DTC is detected.

Is any DTC detected?

YES>>

Perform the trouble diagnosis for the detected DTC. Refer to DTC Index.

NO>>

GO TO 6.

OPERATION CHECK

Confirm that the operation of the around view monitor and the camera image (reference line, expected route) are normal.

WORK END

Additional Service When Replacing Around View Monitor Control Unit

CAUTION: When replacing the around view monitor control unit, always replace it with a new one. Around view monitor system does not operate properly in case of reuse of the around view monitor control ...

Parameter Writing

...

Other materials:

Disposal
CAUTION: When performing disposal operation, wear the protective glasses and protective gloves. Fix back door stay using a vise (C). CAUTION: When cutting a hole on back door stay, always cover a hacksaw (A) using a shop cloth (B) to avoid scattering metal fragments or oil. Using hacksaw slowly m ...

Diagnosis Procedure
CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) With CONSULT Start the engine. CAUTION: The vehicle must be in a stopped state. Connect booster battery (12V) and jumper cable to 12V battery cable. Select “Active test” in “ENGINE”. Select “Auto stop start” in “Active test”. Touch ...

Diagnosis Procedure
LOCATION CHANGE Move the vehicle to other area and repeat the procedure of the easy fill tire alert function. Refer to Easy Fill Tire Alert Function. Is the function normal? YES>> Normal (the tire inflation indicator may not operate, depending on reception condition.) NO>> GO TO 2. P ...

0.0072