Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure
Always perform the distance sensor configuration after replacing the distance sensor.
Always perform the radar alignment after removing and installing or replacing the distance sensor.
CAUTION:
The system does not operate normally unless the distance sensor configuration and the radar alignment are performed. Always perform them.
Perform the AEB system action test to check that the AEB system operates normally.
DISTANCE SENSOR CONFIGURATION
>>GO TO 2.
PERFORM RADAR ALIGNMENT
Perform the radar alignment. Refer to Work Procedure.
>>GO TO 3.
AEB SYSTEM ACTION TEST
Perform the following system action test.
LDW: Refer to Work Procedure.
I-LI: Refer to Work Procedure.
BSW: Refer to Work Procedure.
I-BSI: Refer to Work Procedure.
TSR: Refer to Work Procedure.
RCTA: Refer to Work Procedure.
I-DA: Refer to Work Procedure.
Check that the each system operates normally.
INSPECTION END
Other materials:
Removal and Installation
CAUTION:
Never damage rear door panel.
REMOVAL
CAUTION:
Fully open rear door.
Remove pull handle cap.Apply protective tape (A) on rear door finisher to protect it from damage.
Remove pull handle cap using a remover tool (A).
Remove rear door finisher fixing screws .
Remove inside handle cap.App ...
Work Flow
DETAILED FLOW
INTERVIEW FROM THE CUSTOMER
CAUTION:
>>
GO TO 2.
CHECK SYMPTOM
CAUTION:
>>
GO TO 3.
PERFORM THE SELF-DIAGNOSIS
With CONSULT
Ignition switch OFF (Auto ACC function OFF) to ON.
Perform self-diagnosis for “ABS”.
Is DTC detected?
YES>>
Record or print self-di ...
Special Service Tool
Tool number
(TechMate No.)
Tool name Description —
(J-50190)
Signal tech II
Activate and display TPMS tire pressure sensor IDs
Display tire pressure reported by the TPMS tire pressure sensor
Read TPMS DTCs
Register TPMS tire pressure sensor IDs
Test remote keyless entry keyfob relative signal s ...
0.006