Work Procedure
DESCRIPTION
If only the around view monitor control unit is replaced, the calibration data stored in the camera can be written to the around view monitor control unit by selecting "Camera Calibration" of "Work Support" mode in CONSULT.
WORK PROCEDURE
WRITE CALIBRATION DATA
With CONSULT
-
Select "CALIBRATING CAMERA IMAGE" of "Work Support" mode using CONSULT.
-
After displaying the status, check that the status is displayed as "Normal".
Is the status of each camera displayed as "Normal"?
YES>>INSPECTION END
NO>>Calibrate the camera that is not displayed as "normal". Refer to Work Procedure.
Other materials
Driver Monitor (ProPILOT Assist 2.1)
Basic information
In the Nissan Armada equipped with ProPILOT Assist 2.1, the Driver Monitor system
plays a critical role in ensuring driver awareness and safety. Using a driver-facing
camera mounted on the steering column, the system continuously evaluates the driver’s
attentiveness by ana ...
Front Final Drive Assembly
Exploded View
Flame assembly
Front final drive assembly
Front cross member assembly
: vehicle front
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a pe ...
Front Propeller Shaft: 2f C-C
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
LOOSENESS OF CONNECT ...