Work Procedure
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the air suspension contorol module.
For details the operation, refer to “CONSULT Operation Manual”.
Work Procedure
WRITING VEHICLE SPECIFICATION AND VIN
With CONSULT
Perform writing vehicle specification to air suspension control module according to "Replace ECU" in CONSULT Operation Manual.
NOTE:
-
Ignition switch ON or engine start during writing the vehicle specification and VIN.
-
When "Replace ECU" is performed, VIN registration is completed at the same time. Check that U1A76-55 of "Current DTC" switched to one of "Past DTC".
>>
GO TO 2.
PERFORM NECESSARY WORK
With CONSULT
-
Select "Air suspension" and perform "Work support" in the following order. Refer to Work Support.
-
Venting valve operation check
-
Air filling/pressure measurement
-
Height sensor calibration
-
vehicle height adjustment
-
-
Perform self-diagnosis for “All self diagnosis result”.
-
Erase the memory of self-diagnosis results.
>>
WORK END
Other materials
USB (Universal Serial Bus) charging connector
In the Nissan Armada, the Type-C USB charging connector 1 is предназначен exclusively
for charging external devices such as smartphones, tablets, and other portable electronics.
To begin charging in the Nissan Armada, simply connect a compatible USB device
into the connector. On ...
Noise, Vibration and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and suspected parts SYMPTOM Reference
Noise Shake Vibration Shimmy Judder Poor quality ride or handling
Improper installation, looseness
×
×
×
...
Engine Under Cover
Exploded View
Engine under cover front
Engine under cover rear
N·m (kg-m, ft-lb)
Removal and Installation
WARNING:
REMOVALRemove mounting bolts, and then remove engine under cover rear.
Remove mounting bolts, and then remove engine under cover front.INSTALLATIONInst ...