Work Procedure
-
Always perform the distance sensor configuration after replacing the distance sensor.
-
Always perform the radar alignment after removing and installing or replacing the distance sensor.
CAUTION:
The system does not operate normally unless the distance sensor configuration and the radar alignment are performed. Always perform them.
-
Perform the AEB system action test to check that the AEB system operates normally.
DISTANCE SENSOR CONFIGURATION
Perform saving vehicle internal information according to "Replace ECU" in CONSULT Operation Manual.
>>
GO TO 2.
PERFORM RADAR ALIGNMENT
Perform the radar alignment. Refer to Work Procedure.
>>
GO TO 3.
AEB SYSTEM ACTION TEST
-
Perform the following system action test.
-
LDW: Refer to Work Procedure.
-
I-LI: Refer to Work Procedure.
-
BSW: Refer to Work Procedure.
-
I-BSI: Refer to Work Procedure.
-
TSR: Refer to Work Procedure.
-
RCTA: Refer to Work Procedure.
-
I-DA: Refer to Work Procedure.
-
-
Check that the each system operates normally.
>>
INSPECTION END
Other materials
Transfer Control Unit
Exploded View
Transfer control unit
: N·m (kg-m, in-lb)
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking an ...
Remote Engine Start Function Does Not Operate
Description
Engine does not start when operating REMOTE ENGNE START button of Intelligent Key or telematics function of the smartphone. .NOTE:
Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom.CONDITIONS OF VEHICLE (OPERA ...
Inside Mirror
Exploded View
MANUAL ANTI-DAZZLING
Inside mirror base
Inside mirror assembly
: N·m (kg-m, in-lb)
AUTO ANTI-DAZZLING
Inside mirror base
Inside mirror assembly
: N·m (kg-m, in-lb)
Removal and Installation
REMOVALCAUTION:
Never damage the windshield gl ...