Nissan Armada 2025-2026 Service and Repair Manual: Adjustment Fitting of Front Fender
Fitting adjustment means adjustment of clearance or gradient of the hood, door, front fender, etc. with respect to its adjacent part, and adjustment of gradient at the press line.
Adjustment of front fender is described as an example.
Adjust the fitting at the front fender mounting position. Tighten the front fender mounting bolts loosely, and adjust the fit by moving the front fender sideways or in the up-down direction while observing the clearance with the hood and door.
Adjust the front fender bend angle.
If a proper fit cannot be obtained by step (1) above, change the bending angle of the front fender.
Explanation Condition Correction method When the clearance between the front fender and hood is too small: Apply a flat wood plate to the upper corner of front fender, and correct by hammering. Before hammering, securely tighten the front fender mounting bolts. 
When the clearance between the front fender and hood is too large: Apply a scribing chisel to the bend at the base of the front fender. Tap with a hammer to adjust the clearance. Securely tighten the front fender mounting bolts before tapping. Apply the scribing chisel along the press line. 
Door Hemming
(a) Grind the edge of the door panel using 3M Cubitron II Abrasive Fibre Disc #33415 (grade 60+) or equivalent.
(b) Insert the tip of a sharp-edged tool, such as a chisel, into the clearance at door ...
Adjustment Fitting of Door Assembly
When there is excessive clearance on the upper part of door:
Apply a wood block between the outer sill and the lower side of door, and push the upper part of door.
When there is excessive clearance o ...
Other materials:
Diagnosis Procedure
CHECK HEAD UP DISPLAY MAIN SWITCH OPERATION
With CONSULT
Turn ignition switch ON.
Select "Main switch" in "Data Monitor" mode of "Head Up Display” using CONSULT.
Check "Main switch" indication as per the following condition.
Monitor item Condition Indication Main switch Head Up Display main ...
Precautions when Performing Spot Welding
(1) SELECTION OF SPOT WELDING MACHINE
Use the direct welding method whenever possible.
(When direct welding cannot be applied, use MAG plug welding.)
(2) APPLICATION OF ELECTRODE TIPS
Apply electrodes at right angles to the panel. If they are not applied properly, the current density will be low, r ...
Turning the AEB with Pedestrian Detection system ON/OFF
AEB system OFF warning light (on the meter panel)
Vehicle information display
Steering-wheel-mounted controls (right side)
In the Nissan Armada, the Automatic Emergency Braking (AEB) with Pedestrian Detection
system can be enabled or disabled through the vehicle information display. ...
0.0051