Description
All doors do not lock/unlock using door request switch.
NOTE:
Before starting diagnosis check that vehicle condition is as shown in “Conditions of vehicle”, and check each symptom.
SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)
| Door lock operation (remote keyless entry) | Door lock operation (one touch sensor or request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| OK | NG | OK | OK | OK |
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
Registered Intelligent Key is within the detection area of outside key antenna.
DIAGNOSIS PROCEDURE
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
>>
GO TO 2.
PERFORM SELF-DIAGNOSIS RESULT
Select “Self Diagnostic Result” mode of “INTELLIGENT KEY”, and check if DTC is detected.
Is DTC detected?
YES>>Perform the trouble diagnosis for detected DTC.
NO>>GO TO 3.
CHECK OUTSIDE KEY ANTENNA
Check outside key antenna.
-
Rear door LH: Refer to DTC Diagnosis Procedure.
-
Rear door RH: Refer to DTC Diagnosis Procedure.
-
Rear bumper: Refer to DTC Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Repair or replace the malfunctioning parts.
CHECK ONE TOUCH SENSOR
Check request switch.
-
Front door LH:Refer to DTC Diagnosis Procedure.
-
Front door RH:Refer to DTC Diagnosis Procedure.
-
Rear door LH:Refer to Diagnosis Procedure.
-
Rear door RH:Refer to Diagnosis Procedure.
-
Back door:Refer to DTC Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 5.
NO>>Repair or replace the malfunctioning parts.
REPLACE INTELLIGENT KEY UNIT
-
Replace Intelligent Key unit. Refer to Removal and Installation.
-
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials
Back Door Trim
Exploded View
Back door panel
Back door upper garnish
Back door side garnish RH
Back door lower finisher
Back door pull handle
Back door finisher cap*1
Automatic back door switch finisher*2
Back door inner finisher
Back door side garnish LH
: Clip
: Pawl
: Metal ...
Front Combination Lamp
Exploded View
Radiator core support
Front combination lamp
Front fender assembly
: N·m (kg-m, in-lb)
Removal and Installation
CAUTION:
Disconnect the battery negative terminal or remove power circuit fuse when performing the operation for preventing electric leakage. Refer to Precaut ...
Mac Key Writing
Description
When replacing around view monitor control unit, it is necessary to write MAC key to around view monitor control unit. Write MAC key to around view monitor control unit according to "MAC Key writing" procedure of "CONSULT Operation Manual". Refer to Work Procedure.CAUTION:
During MAC key ...