Description
Approach unlock/walk away lock function does not operate.
NOTE:
Before starting diagnosis check that vehicle condition is as shown in “Conditions of vehicle”, and check each symptom.
SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)
| Door lock operation (remote keyless entry) | Door lock operation (one touch sensor or request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| OK | OK | OK | OK | NG |
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
-
“Walk Away Lock” and “Approach Unlock” of the "vehicle setting" in the combination meter is ON.
-
Registered Intelligent Key is within the detection area of outside key antenna.
DIAGNOSIS PROCEDURE
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table. Refer to Diagnosis Procedure.
>>
GO TO 2.
CHECK OUTSIDE KEY ANTENNA
Use SIGNAL TECH II to check each outside key antenna. For the inspection method and how to use SIGNAL TECH II, refer to “NISSAN/INFINITI SIGNAL TECH II USER GUIDE”.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace the malfunctioning parts.
REPLACE INTELLIGENT KEY UNIT
-
Replace Intelligent Key unit. Refer to Removal and Installation.
-
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials
Transfer Assembly
Exploded View
Transfer assembly
: N·m (kg-m, ft-lb)
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Li ...
Additional Service When Replacing Third Seat Control Unit Lh
Description
When after replacing third seat control unit LH, third seat LH position initialization must be performed. For details, refer to Work Procedure.
Work Procedure
REPLACE THIRD SEAT CONTROL UNIT LH
Replace third seat control unit LH. Refer to Removal and Installation.
>>
GO TO 2.
TH ...
Key Reminder Function Does Not Operate
Diagnosis Procedure
CHECK DOOR SWITCH
Check door switch.
Refer to Component Function Check.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHECK UNLOCK SENSOR
Check unlock sensor.
Refer to Diagnosis Procedure.
Is the inspection result n ...