Description
All doors do not lock/unlock using Intelligent Key button. (One Intelligent Key has the symptom, other keys operate normally.)
SYMPTOM TABLE (ONE INTELLIGENT KEY HAS THE SYMPTOM, OTHER KEYS OPERATE NORMALLY)
| Door lock operation (remote keyless entry) | Door lock operation (one touch sensor or request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| NG | OK | OK | OK | OK |
DIAGNOSIS PROCEDURE
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
>>
GO TO 2.
REGISTER INTELLIGENT KEY
-
Register the Intelligent Key again.
-
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>GO TO 3.
REPLACE INTELLIGENT KEY
-
Replace the Intelligent Key and perform registration again.
-
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>GO TO 4.
REPLACE INTELLIGENT KEY UNIT
-
Replace Intelligent Key unit. Refer to Removal and Installation.
-
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials
Exit Assist Function Does Not Operate
Diagnosis Procedure
CHECK SYSTEM SETTING
Check system setting. Refer to Description.
Check exit assist function operation.
Does it operate normally?
YES>>
Exit assist function is normal.
NO>>
GO TO 2.
CHECK DOOR SWITCH (DRIVER SIDE)
Check door switch (driver side). Refer to Compo ...
Intelligent Key Battery
Removal and Installation
Release the lock knob at the back of the Intelligent Key and remove the mechanical key.
Insert remover tool (A) wrapped with a cloth into the slit 1 of the corner and twist 2 it to separate the upper part from the lower part.
CAUTION:
Never touch the circuit board or ...
Intelligent Key
Description
Automatic back door open/close function does not operate using Intelligent Key.
Diagnosis Procedure
CHECK REMOTE KEYLESS ENTRY FUNCTION
Check remote keyless entry function.
Does door lock/unlock with Intelligent Key button?
YES>>
GO TO 2.
NO>>
Refer to Diagnosis Procedure.
...