Symptom Table
AROUND VIEW MONITOR SYSTEM
| Symptoms | Check items | Probable malfunction location | |
|---|---|---|---|
| Screen is not switched to camera image, when camera switch is pressed and when shift position is shifted to the reverse position. | “AROUND VIEW MONITOR” is not displayed on the system selection screen of CONSULT. | Around view monitor control unit power supply circuit | |
|
Check that the following "DATA MONITOR" items operate normally using CONSULT
|
"CAMERA SWITCH SIGNAL" and "REVERSE SIGNAL" are normal | Around view monitor control unit | |
| "CAMERA SWITCH SIGNAL" or "REVERSE SIGNAL" is not normal | CAN communication | ||
| Screen is switched when pressing camera switch or shifting selector lever to the reverse position, however, all views are not displayed. | Only superimposing is displayed (only images that AV control unit plots are displayed). | LVDS (between around view monitor control unit and each camera) | |
| Superimposing is not displayed. | AV control unit or LVDS (between around view monitor control unit and AV control unit) | ||
| The screen is not switched to the rear view image even if the selector is shifted to the reverse position. | The front view is displayed normally. | CAN communication (Reverse signal) | |
|
Check the following "DATA MONITOR" items using CONSULT.
|
NG | LVDS (between front camera and around view monitor control unit) |
| OK | Front camera | ||
|
Check the following "DATA MONITOR" items using CONSULT.
|
NG | LVDS (between rear camera and around view monitor control unit) |
| OK | Rear camera | ||
|
Check the following "DATA MONITOR" items using CONSULT.
|
NG | LVDS (between side camera LH and around view monitor control unit) |
| OK | Side camera LH | ||
| Right side of top view image is not displayed. |
Check the following "DATA MONITOR" items using CONSULT.
|
NG | LVDS (between side camera RH and around view monitor control unit) |
| OK | Side camera RH | ||
Other materials
RAB system limitations
WARNING
The following limitations apply to the Rear Automatic Braking (RAB) system
in the Nissan Armada. Failure to fully understand and follow these limitations may
result in serious injury or even fatal accidents.
When the Nissan Armada approaches an obstacle while the accelerator or
b ...
Positive Crankcase Ventilation
Inspection
Start engine and let it idle.
Replace PCV valve from the rocker cover. Refer to Removal and Installation.
Connect PCV valve to PCV hose.
Block and unblock the air hole of PCV valve and check if a hissing noise can be heard from the air hole.
Is the inspection result normal?
YES >> ...
Vin Registration
Work Procedure
VIN Registration is an operation to register the VIN in ADAS control unit.CHECK VIN
Check VIN of vehicle and note it. For VIN stamped position, refer to Information About Identification or Model Code .
>>
GO TO 2 .
PERFORM VIN REGISTRATION
With CONSULT
Ignition switch ON.
...