Automatic back door open/close function does not operate using back door opener switch.
Diagnosis Procedure
Diagnosis ProcedureWelding of Ultra High Strength Steel
SPOT WELDING
Spot welding is limited to ultra high strength steel (tensile strength: 980 MPa) according to the welding conditions listed below.
CAUTION:
If the below welding conditions cannot be met, then perform plug welding.
Never spot weld ultra high strength steel of tensile strength more than 9 ...
Diagnosis Procedure
CHECK DTC WITH AUTOMATIC BACK DOOR CONTROL UNIT
Check that DTC is not detected with automatic back door control unit.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Refer to DTC Index.
CHECK TOUCH SENSOR LH
Check touch sensor LH.
Refer to DTC Diagnosis Procedure.
Is the inspecti ...
NVH Troubleshooting Chart
SUSPECTED PARTS
(Possible cause) Symptom Reference Transfer fluid leakage Noise TRANSFER FLUID (Level low) 1 Inspection TRANSFER FLUID (Wrong) 4 2 TRANSFER FLUID (Level too high) 1 LIQUID GASKET (Damaged) 2 Exploded View OIL SEAL (Worn or damaged) 2 Front oil seal: Exploded View
Rea ...