NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Owner's Manual: Basic information

Nissan Armada 2025-2026 Owner's Manual / Starting and driving / Lane Departure Warning (LDW)/Intelligent Lane Intervention (I-LI) / Basic information

WARNING

Failure to properly follow the instructions and safety guidelines for the Nissan Armada LDW and I-LI systems may result in serious injury or even fatal consequences.

  • The Nissan Armada LDW and I-LI systems are driver-assist technologies and will not take full control of steering or prevent loss of vehicle control. The driver must remain attentive, maintain proper lane position, and always retain full control of the Nissan Armada.
  • These systems are primarily designed for use on well-marked highways and freeways. Under certain driving, weather, or road conditions, the Nissan Armada may not accurately detect lane markings, which can affect system performance.

 

  • Lane Departure Warning (LDW) system
    • In the Nissan Armada, the LDW system alerts the driver through visual indicators on the vehicle information display and steering wheel vibration when the vehicle unintentionally drifts out of its lane.
  • Intelligent Lane Intervention (I-LI) system
    • The Nissan Armada I-LI system enhances safety by not only warning the driver but also applying gentle steering assistance to help guide the vehicle back toward the center of the lane.
    Other materials

    Precautions
    Precautions for Removing Battery Terminal When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below. NOTE: Some ECUs operate for a certain fixed time even after ignit ...

    Additional Service When Replacing Transfer Control Unit
    Description When replacing transfer control unit, the following work is required. For the work procedure, refer to Work Procedure.WORK AFTER REPLACEMENT Unit parameter writing Initial calibration Work Procedure WRITING THE REQUIRED INFORMATION FOR CONTROL UNIT REPLACEMENT With CONSULT Ignitio ...

    Rack End Value Reset
    Work Procedure NOTE: When steering column assembly and steering gear assembly are replaced, rack end value reset (steering wheel turning angle learning value reset) is performed. When the toe-in is adjusted, back end value reset (steering wheel turning angle learning value reset) is performed. ...