WARNING
- Never attempt to lift two wheels of the Nissan Armada off the ground while the engine is running and shift the transmission into any drive or reverse position. This improper procedure may cause severe drivetrain damage or unexpected vehicle movement, potentially leading to serious damage or personal injury.
- Do not test a Nissan Armada equipped with All-Mode 4WD on a two-wheel dynamometer or similar testing equipment, even if the remaining wheels are elevated. Always inform service personnel that your Nissan Armada is equipped with a 4WD system before any diagnostic procedure. Using incorrect testing equipment may result in drivetrain failure or uncontrolled vehicle movement, creating a significant safety risk.
CAUTION
- Avoid operating the Nissan Armada in 4H or 4L modes on dry, hard-surfaced
roads. Driving under these conditions in 4WD modes can lead to unnecessary drivetrain
stress, increased tire wear, higher fuel consumption, and noticeable drivetrain
noise.
If a Four-Wheel Drive (4WD) warning message appears while driving your Nissan Armada on dry pavement, take immediate corrective action:
- If the vehicle is in 4H mode, switch the 4WD control to AUTO mode. Note that if the system is operating in fail-safe mode, it may remain in 4H even on paved roads.
- If the Nissan Armada is in 4L mode (if equipped), bring the vehicle
to a complete stop. Depress the brake pedal, shift the transmission into
"N" (Neutral), and then switch the 4WD selector to AUTO mode. In fail-safe
conditions, the system may remain locked in 4L regardless of surface conditions.
If the 4WD warning message continues to be displayed after performing these steps, have your Nissan Armada inspected as soon as possible. It is strongly recommended to consult an authorized NISSAN dealer for professional service.
- Continuing to drive the Nissan Armada while the 4WD warning message is active may result in serious transfer case damage and costly repairs.
- After disconnecting and reconnecting the battery, the Nissan Armada
4WD system may automatically reset from 4L (if equipped) to AUTO mode.
If the 4WD indicator alternates between "AUTO" and "4L" and then continues blinking on "AUTO", press the brake pedal and shift the transmission into "N" (Neutral). This procedure will stop the blinking indicator and restore normal system operation.
Other materials
Unit Parameter Writing
Description
After working the following, transfer unit parameter must be written to transfer control unit.
Transfer control unit replacing
Transfer assembly replacing
Transfer control actuator replacing
Transfer range position sensor replacing
Transfer cam position sensor replacing
Transf ...
Back Door Lock
Exploded View
Back door touch sensor*1
Back door lock & closure assembly
Back door panel
Back door stay lower bracket
Spindle unit*1
Spindle unit bracket upper*1
Bracket cover*2
Hands free control unit*2
Hands free sensor bracket*2
Hands free sensor upper*2
Hands free ...
Driving Video Recorder Control Module
Removal and Installation
REMOVALCAUTION:
Before replacing driving video recorder control module, perform “ADDITIONAL SERVICE WHEN REPLACING DRIVING VIDEO RECORDER CONTROL MODULE”. For details, refer to Work Procedure.
Before replacing the driving video recorder control module, the customer s ...