Description
Both side headlamps (HI) are not turned ON when setting to the lighting switch HI or PASS.
Diagnosis Procedure
COMBINATION SWITCH INSPECTION
Check combination switch. Refer to Symptom Table.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace the malfunctioning part.
CHECK HIGH BEAM REQUEST SIGNAL
With CONSULT
-
Select “High beam request” in “Data Monitor” mode of “IPDM E/R” using CONSULT.
-
With operating the lighting switch, check the monitor status.
Monitor item Condition Monitor status High beam request Lighting switch
(2ND)HI On LO Off
Is the inspection result normal?
YES>>Replace IPDM E/R. Refer to Removal and Installation.
NO>>Replace BCM. Refer to Removal and Installation.
Other materials
NISSAN Advanced Air Bag System (front seats)
Crash zone sensor
Supplemental front-impact air bag modules (NISSAN Advanced Air Bags)
Occupant classification system control unit
Occupant classification sensors (weight sensors)
Front central seat-mounted side-impact supplemental air bag (if so equipped)
Roof-mounted curtain side- ...
System maintenance
Example
Basic information
The two radar sensors A for the I-BSI system are located near the rear bumper.
Always keep the area near the radar sensors clean.
The radar sensors may be blocked by temporary ambient conditions such as snow,
splashing water, mist or fog.
The blocked condition ma ...
Rear Suspension Tools and Preparation
Special Service Tools
The actual shapes of TechMate tools may differ from those of special service tools illustrated here.
Tool number
(TechMate No.)
Tool name Description
ST3127S000
(NI-25765-A)
Preload gauge
Measuring rotating torque of ball joint
KV401110S0
( - )
Rear shock absorber s ...