Description
LED HEADLAMP
-
LED brightness and color may slightly change until the temperature becomes stable. This is not malfunction.
-
Illumination time lag may occur between right and left. This is not malfunction.
-
Brightness may be reduced due to aged deterioration of LED.
INTELLIGENT AUTO LIGHT SYSTEM
The headlamp may not be turned ON/OFF immediately after passing dark area or bright area (short tunnel, sky bridge, shadowed area etc.) while using the intelligent auto light system. This causes for the control difference. This is normal.
HIGH BEAM ASSIST SYSTEM
When driving while using the high beam assist system, the headlamp beam may not switch or the beam switching timing may vary according to the ambient environment (the condition of the vehicle ahead, the condition of the road, the position of the vehicle, etc.).This is due to control differences and is not a malfunction.
Other materials
Precautions
Precautions for Removing Battery Terminal
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.
NOTE:
Some ECUs operate for a certain fixed time even after ignit ...
Front Automatic Air Conditioning System
Symptom Table
NOTE:
Perform self-diagnoses with CONSULT before performing the symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis. Symptom Corresponding malfunction part Check item/Reference
Front air conditioning system does not activate.
NOTE:
Fail-safe does not acti ...
Additional Service When Replacing Distance Sensor
Work Procedure
Always perform the distance sensor configuration after replacing the distance sensor.
Always perform the radar alignment after removing and installing or replacing the distance sensor.
CAUTION:
The system does not operate normally unless the distance sensor configuration and the r ...