Description
When the following work is performed, it is necessary to perform initial setting of automatic back door position information to operate automatic back door system. Refer to Work Procedure.
-
After removing and installing, or replacing back door assembly
-
After removing and installing, or replacing spindle unit
Work Procedure
STEP 1
-
Select “AUTOMATIC BACK DOOR� using CONSULT.
-
Select “Reset auto back door status� of “WORK SUPPORT� mode.
-
Touch “Initialize� to erase automatic back door position information.
>>
GO TO 2.
STEP 2
Fully close the back door manually.
>>
GO TO 3.
STEP 3
Operate back door opener switch and perform automatic open operation.
>>
GO TO 4.
STEP 4
-
The back door fully opens.
-
Check that automatic back door warning buzzer sounds normally.
Does automatic back door warning buzzer sound normally?
YES>>GO TO 5.
NO>>GO TO 2.
STEP 5
Fully close the back door.
>>
WORK END
Other materials
Performance Test
Inspection
INSPECTION PROCEDURE
Connect recovery/recycling/recharging equipment (for HFO-1234yf) or manifold gauge.
Start the engine, and set to the following condition.
Test condition Surrounding condition
Indoors or in the shade
(in a well-ventilated place)
vehicle condition
Door
Closed ...
Insufficient Heating
Front Air Conditioner
Description
Symptom
Insufficient heating
No warm air comes out. (Air flow volume is normal.)
Diagnosis Procedure
NOTE:
Perform self-diagnoses with CONSULT before performing symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis.CHECK COOLING SYSTEM ...
Rear Wiper
Exploded View
Rear wiper motor
Rear wiper blade
Rear wiper arm
Pivot seal
: N·m (kg-m, in-lb)
Rear Wiper Arm
Removal and Installation
CAUTION:
Clean back door window glass and rear wiper refill so that back door window glass may not be damaged by dust, ...