Nissan Armada 2025-2026 Service and Repair Manual: Calibration of Automatic Back Door Position Information
When the following work is performed, it is necessary to perform initial setting of automatic back door position information to operate automatic back door system. Refer to Work Procedure.
After removing and installing, or replacing back door assembly
After removing and installing, or replacing spindle unit
Work Procedure
WRITING VEHICLE SPECIFICATION
With CONSULT
Perform writing vehicle specification to Intelligent Key unit following "Automatic Configuration" procedure of "Configuration" according to CONSULT Operation ...
Work Procedure
STEP 1
Select “AUTOMATIC BACK DOOR” using CONSULT.
Select “Reset auto back door status” of “WORK SUPPORT” mode.
Touch “Initialize” to erase automatic back door position information.
...
Other materials:
Work Procedure
PERFORM ECM RECOMMUNICATING FUNCTION
Install ECM.
Contact backside of the registered Intelligent Key* to push-button ignition switch while push switch is pressed, then turn ignition switch ON.
*: To perform this step, use the key that is used before performing ECM replacement.
Maintain ignition swit ...
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
Jump starting
To start your Nissan Armada engine using a booster battery, it is essential to
carefully follow the proper procedures and safety precautions outlined below to
avoid damage or injury.
WARNING
Improper jump starting of the Nissan Armada can result in a battery explosion,
causing severe inj ...
0.0051