Nissan Armada 2025-2026 Service and Repair Manual: Checking Damage
When completing body and frame repairs, the front body and underbody dimensions must be correct, because these dimensions directly affect wheel alignment and steering angles.
The degree of damage should be determined by using a steel tape, tram tracking gauge and centering gauge or other measuring device. The measuring points are shown in the Body Repair Manual for each model. Wheel alignments are shown in the Service Manual for each model.
Parts to be Replaced
High-strength steel parts: The strength of these parts will be reduced if repaired by heating.
Parts relating to body alignment and wheel alignment: Replacement of such parts would not provide proper ...
Tracking Gauge and Steel Tape
Measure the distance between two points. Before using the tracking gauge, check the measuring points with the steel tape.
(1) TRACKING GAUGE
Fit the tracking gauge correctly to the measuring point.
T ...
Other materials:
Removal & Installation
REMOVAL
Remove the map lamp assembly. Refer to Removal and Installation.
Remove the microphone harness connector .
Use a suitable tool to release pawl and remove the switch finisher .
: Pawls
CAUTION:
Do not damage pawl.
Use a suitable tool to release pawls and remove the moonroof switch asse ...
Precaution for Electronic Air Suspension System
WARNING:
When removing the air suspension component parts, always follow the removing procedure of each component parts since the vehicle height may accidentally drop and it can lead to personal injury.
CAUTION:
Never expand and contract the air spring of shock absorber.
Never expand and contract t ...
Inspection
INSPECTION AFTER REMOVAL
When turn the shaft in direction , check returning to direction by spring power.
CAUTION:
The maximum turning force shall be 5 N·m (0.51 kg-m, 44 in-lb).
When turn the shaft in direction , check locking the shaft. INSPECTION AFTER INSTALLATION
ADJUSTMENT AFTER INSTALLATIO ...
0.0056