Removal and Installation
REMOVAL
CAUTION:
-
Perform lubricant return operation before each refrigeration system disassembly. However, if a large amount of refrigerant or lubricant leak is detected, never perform lubricant return operation. Refer to Perform Lubricant Return Operation.
-
When disconnect the A/C piping related parts, cap or wrap the joint of those parts with suitable material such as vinyl tape to avoid the entry of air.
Use a refrigerant collecting equipment (for HFO-1234yf) to discharge the refrigerant. Refer to Recycle Refrigerant.
Remove front grille. Refer to the following.
-
Off road models: Removal and Installation
-
City models: Removal and Installation
Remove radiator air guide upper. Refer to Removal and Installation.
Disconnect high-pressure flexible hose from condenser inlet pipe. Refer to Removal and Installation.
Remove front bumper side finisher LH. Refer to the following.
-
Off road models: Removal and Installation
-
City models: Removal and Installation
Remove mounting bolt
.

Remove mounting bolt
, and then disconnect condenser inlet pipe from condenser & liquid tank assembly.

| : vehicle front |
Remove condenser inlet pipe from vehicle.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
To prevent leakage of refrigerant, replace the O-ring with a new one. Apply a coat of compressor oil to the O-ring prior to installation.
-
Use a refrigerant collecting equipment (for HFO-1234yf) to charge the refrigerant. Refer to Charge Refrigerant.
-
Perform a check for refrigerant leakage when charging with refrigerant. Refer to Leak Test.
Other materials
Warning/indicator lights (red)
Brake warning light
or
In the Nissan Armada, the brake warning light is a critical safety indicator
that helps monitor the condition of the braking system. When the ignition switch
is turned to the ON position, this light should illuminate briefly for a few seconds
and then turn off, ...
Torque Converter and Converter Housing Oil Seal
Exploded View
A/T assembly
Converter housing oil seal
Seal ring
Torque converter
: Always replace after every disassembly.
: Apply ATF
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a p ...
Noise, Vibration, and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
Possible cause and SUSPECTED PARTS Symptom Reference
Vibration Shake Noise
Uneven rotating torque
×
×
Inspection
Center bearing improper installation
×
×
×
Exploded View
Excessive center bearing axial end play
×
×
Inspection
Ce ...