Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the BCM.
The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the vehicle specification to the BCM.
Refer to Work Procedure.
NOTE:
For details the network connection and operation, refer to “CONSULT Operation Manual�.
The configuration no need to “save� configuration data from the BCM. The configuration data is always generated freshly at the server and then downloaded to the CONSULT.
CAUTION:
-
Complete the procedure of “Configuration� in order.
-
If incorrect “Configuration�, incidents might occur.
-
Never perform “Configuration� except for new BCM.
Work Procedure
WRITING VEHICLE SPECIFICATION
With CONSULT
-
Ignition switch ON.
-
Perform writing vehicle specification to BCM following "Automatic Configuration" procedure of "Configuration" according to CONSULT Operation Manual.
NOTE:
-
Log in the network according to CONSULT guidance.
-
For details the network connection and operation, refer to “CONSULT Operation Manual�.
>>
WORK END
Other materials
About microSD card
WARNING
Never allow children to handle or play with the microSD card used in your
Nissan Armada. Due to its small size, accidental swallowing may occur, which can
lead to choking, serious injury, or even life-threatening situations.
NOTE:
If the microSD card is removed from the Nissan Armada ...
Electric Shift Selector
Exploded View
Front center console switch finisher assembly
Electric shift selector
Removal and Installation
CAUTION:
Never disassemble the electronic shift selector.
When holding the electronic shift selector, hold the vehicle mounting part.
Never allow foreign materials to enter into ...
Rear View Camera
Removal & Installation
REMOVALRemove back door finisher. Refer to Removal and Installation.
Remove the rear view camera mounting screws , then remove the rear view camera .
INSTALLATIONInstall in the reverse order of removal.NOTE:
Adjust the guide line position if the guide line position is shi ...