Diagnosis Procedure
FilamentWork Procedure
When driver monitor camera control unit is replaced, be sure to perform the specified incidental work in order to operate system normally.
DRIVER MONOTOR CAMERA CONTROL UNIT CONFIGURATION
>>
GO TO 2.
CHECK DATA MONITOR
Check that "Face" is "within range" in "Data monitor" of "Driver Monitor ...
Removal and Installation
REMOVAL
Fully open fuel filler base assembly.
Disengage fuel filler lid fixing pawl using a removal tool (A), and then remove fuel filler lid according to numerical order 1→2 indicated by arrows as shown in figure.
: Pawl
INSTALLATION
Note the following items, and then install in the reve ...
Removal and Installation
REMOVAL
Apply protective tapes (A) on the part to protect it from damage.
Disengage fixing pawls and peel off double-sided tapes using a remover tool (A), and then remove front fender duct .
: Pawl
Remove double-sided tape with a double-sided tapes remover from front fender duct and front fen ...