Diagnosis Procedure
CHECK SYMPTOM
Check the symptoms.
A stop/start indicator lamp turned on, and did an engine perform a stall at the time of restart from a stop/start system?
YES>>GO TO 2.
NO>>Refer to Symptom Table.
CHECK STOP/START PROHIBIT CAUSE
With CONSULT
Select “Stop/Star engine stall cause data recorder” in “Work support” mode of “ENGINE” using CONSULT.
Is the cause of the engine not starting recorded?
YES>>Eliminate the cause and complete the inspection.
NO>>GO TO 3.
CHECK STARTER MOTOR (SUB STARTER & ALTERNATOR) OPERATION
Check the stater motor (sub starter & alternator *if equiped ) operation when engine restart during stop/start system operation.
Is the starter motor operated?
YES>>Refer to Symptom Table.
NO>>Perform “All DTC Reading” with CONSULT and perform trouble diagnosis for DTC indicated.
Other materials
Hill descent control switch
WARNING
In the Nissan Armada, never rely exclusively on the hill descent control
system to regulate vehicle speed on steep downhill slopes. Always maintain full
control of the vehicle and be prepared to apply the brake pedal when necessary.
Extra caution is required when driving on ...
Mixture Ratio Self-Learning Value Clear
Description
This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure”. (For details, refer to Work Procedure .)
Work Procedure
START
With CONSULT
Start engine and warm it up to normal operating temperature.
O ...
Rear Door Parting Seal
Removal and Installation
REMOVALRear Door Parting Seal FrontFully open rear door.
Remove rear door parting seal front clip.Apply protective tape (A) to rear door panel around rear door parting seal front clip for preventing damage.
Disengage fixing pawls using a remover tool (A), and then remove re ...