Diagnosis Procedure
NOTE:
Check the stop/start system operation condition. Refer to System Description.
CHECK STOP/START PROHIBIT CAUSE
With CONSULT
Select “Stop/Start prohibit cause data recorder” in “Work support” mode of “ENGINE” using CONSULT.
Does "Stop/Start prohibit cause data recorder" show fail-safe?
YES>>GO TO 2.
NO>>Check the operating status of system stop / start. Refer to System Description. After confirmation, go to 4.
CHECK "Stop/Start error" OF CONSULT DATA MONITOR ITEM
With CONSULT
-
Select "Stop/Start error" in "Monitor Menu" of “Data monitor” mode in CONSULT.
-
Check the displayed data monitor items. Refer to CONSULT Function.
Are there any "NG" monitor items?
YES>>After confirming the "NG" item, go to 3.
NO>>GO TO 3.
CHECK DTC
With CONSULT
Perform “All DTC Reading” with CONSULT.
Does it detect the DTC associated with "Stop/Start error" of “Data monitor”?
YES>>Perform trouble diagnosis of detected DTC. After repairing the defective part, go to 4.
NO>>GO TO 4.
CHECK STOP/START INDICATOR / LAMP
Check the stop/start indicator / lamp.
| WARNING LAMP/INDICATOR LAMP / INDICATOR | CONDITION |
|---|---|
| Stop/start indicator / lamp | Not blinking |
Is the stop/start indicator / lamp blinking?
YES>>Refer to Symptom Table.
NO>>INSPECTION END
Other materials
Seat Memory Switch
Removal and Installation
REMOVALRemove front door finisher. Refer to Removal and Installation.
Disengage the fixing pawls using a remover tool (A) and then remove seat memory switch.
: Pawl
INSTALLATIONInstall in the reverse order of removal. ...
Outside Key Antenna
Rear Door
Removal and Installation
REMOVALRemove rear door finisher. Refer to Removal & Installation.
Disconnect outside key antenna (rear door) harness connector.
Disengage outside key antenna (rear door) fixing clips, and then remove outside key antenna (rear door) .
: Clip
Disengage ...
Repairing Material
Foam Repair
During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.URETHANE FOAM APPLICATIONSUse commercially available Urethane foam for sealant (foam materi ...