Description
All doors do not lock/unlock using door request switch and engine does not start when push-button ignition switch is pressed while carrying Intelligent Key.
SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)
| Door lock operation (remote keyless entry) | Door lock operation (one touch sensor or request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| NG | NG | No crank, No start | OK | NG |
DIAGNOSIS PROCEDURE
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
>>
GO TO 2.
CHECK INTELLIGENT KEY BATTERY
Check Intelligent Key battery.
Refer to Component Inspection.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace the malfunctioning parts.
REPLACE INTELLIGENT KEY UNIT
-
Replace Intelligent Key unit. Refer to Removal and Installation.
-
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials
BSW system operation
Side indicator light
BSW indicator (vehicle information display)
Vehicle information display
Steering-wheel-mounted controls (right side)
The Nissan Armada BSW system becomes active at speeds above approximately 20
MPH (32 km/h), ensuring effective operation during typical driving ...
Normal Operating Condition
Description
When the back door position is in the range of [between "just before fully closed" and the position approximately less than 150 mm (5.91 in) from "just before fully closed" ], the back door does not operate even if any of switches are operated.
To operate the back door by switches, ...
Action Test
Work Procedure
After repairing the malfunction symptom of ProPILOT Assist 2.1, perform an operation check of ProPILOT Assist 2.1 and check that ProPILOT Assist 2.1 operates normally.CAUTION:
Always drive safely when performing the action test.CHECK FOR ProPILOT ASSIST SWITCH
Start the engine.
Pr ...