Nissan Armada 2025-2026 Service and Repair Manual: Exploded View
 | Drive pinion lock nut |  | Companion flange |  | Front oil seal |
 | Pinion front bearing |  | Collapsible spacer |  | Gasket |
 | Filler plug |  | Drain plug |  | Mounting insulator |
 | Gear carrier |  | Mounting insulator |  | Breather connector |
 | Side shaft bearing |  | Snap ring |  | Snap ring |
 | Side oil seal |  | Side shaft |  | Pinion rear bearing |
 | Pinion height adjusting washer |  | Drive pinion |  | Drive gear |
 | Differential assembly |  | Carrier cover |  | Bearing cap |
 | Side bearing |  | Side bearing adjusting washer |  | Spacer |
 | Side oil seal | ||||
 | Screw hole |  | Comply with the assembly procedure when tightening. Refer to Disassembly and Assembly. | ||
 : N·m (kg-m, ft-lb) | |||||
 : Always replace after every disassembly. | |||||
 : Select with proper thickness. | |||||
 : Apply Genuine Liquid Gasket, Three Bond 1217 or equivalent. Refer to Recommended Chemical Products and Sealants. | |||||
 : Apply Genuine High Strength Thread Locking Sealant, Loctite 270 or equivalent. Refer to Recommended Chemical Products and Sealants. | |||||
Disassembly and Assembly
DISASSEMBLY
Remove mounting insulators with drift [SST: ST33200000 (NI-26082)] if necessary.
Remove side shaft assembly. Refer to Disassembly and Assembly.
Remove side oil seal from gear carrier with ...
Other materials:
Removal and Installation
REMOVAL
Remove rear door finisher. Refer to Removal and Installation.
Remove rear door inside handle fixing screws .
Remove rear door inside handle fixing pawls, and then remove rear door inside handle.
：Pawl
INSTALLATION
Note the following items, and then install in the reverse order of re ...
Work Procedure
CHOOSE METHOD
There are two ways of learning method.
Which method do you choose?
With CONSULT>>
GO TO 2.
Without CONSULT>>
GO TO 3.
WITH CONSULT
With CONSULT
Ignition switch ON.
Perform "Steering column position learning” in "Work support" mode of "STEERING COLUMN” using CONSULT.
...
Service After Replacing or Removing Engine Parts
×:Applicable
Part name Service performed Service Manual item Reference Replacement Removal ECM × — Additional service when replacing ECM Refer to Work Procedure. Accelerator pedal position sensor × ×*1 Accelerator pedal released position learning Refer to Work Procedure. Electr ...
0.0051