Flat towing
Flat towing—also referred to as dinghy towing or “4-down� towing—means towing your Nissan Armada with all four wheels in contact with the ground.
This method is commonly used when a vehicle is towed behind a motorhome or recreational vehicle. However, it is critical to understand that not all configurations of the Nissan Armada are designed for this type of towing.
CAUTION
- Failure to follow the correct towing procedures for your Nissan Armada can result in severe and costly transmission damage.
- When towing your Nissan Armada, always tow the vehicle forward—never backward—to prevent drivetrain damage.
- DO NOT flat tow any Nissan Armada equipped with an automatic transmission. Towing with all four wheels on the ground will cause internal transmission damage due to insufficient lubrication.
- DO NOT tow any Four-Wheel Drive (4WD) Nissan Armada with any wheels on the ground, as this can result in serious damage to the transfer case and drivetrain components.
Automatic Transmission
Four-Wheel Drive (4WD) models
Four-wheel drive Nissan Armada models must never be towed with any wheels in contact with the ground. Always use proper transport equipment such as a flatbed truck.
Two-Wheel Drive (2WD) models
For two-wheel drive Nissan Armada models equipped with an automatic transmission, towing requires the use of a suitable vehicle dolly.
The dolly must support the drive wheels of the vehicle to prevent transmission damage. Always follow the manufacturer’s guidelines when using towing equipment with your Nissan Armada.
Other materials
Back Door Auto Closure Function Does Not Operate
Automatic Back Door Control Unit
Diagnosis Procedure
CHECK DTC WITH AUTOMATIC BACK DOOR CONTROL UNIT
Check that DTC is not detected with automatic back door control unit.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Refer to DTC Index.
CHECK OPEN SWITCH
Check open switch.
Refe ...
Side Camera
Removal and Installation
REMOVAL
Remove the door mirror finisher. Refer to Disassembly and Assembly.
Remove the side camera mounting screw , and then remove the side camera .
INSTALLATIONInstall in the reverse order of removal.
Perform parameter writing. (With ProPILOT Assist 2.1) Refer to Work ...
Steering Torque Calibration
Work Procedure
After replacing the ADAS control unit 2 and after replacing or removing the following steering components, the steering torque calibration is necessary to operate the system normally.
Steering wheel
Spiral cable
Steering angle sensor
Steering column assembly
Steering gear ass ...