WARNING:
Install reservoir tank if removed, and radiator drain plug.
CAUTION:
Be sure to clean drain plug and install with new O-ring.
| Tightening torque | Refer to RADIATOR : Exploded View. |
If water drain plug on cylinder block is removed, close and tighten it. Refer to Setting.
Fill radiator and reservoir tank with water and reinstall radiator cap and reservoir tank cap. Refer to ENGINE COOLANT : Refilling.
Run the engine and warm it up to normal operating temperature.
Rev the engine two or three times under no-load.
Stop the engine and wait until it cools down.
Drain water from the system. Refer to ENGINE COOLANT : Draining.
Repeat steps 1 through 6 until clear water begins to drain from radiator.
Check that the radiator cap and reservoir tank cap is tightened.
RefillingSymptom Table
AROUND VIEW MONITOR SYSTEM
Symptoms Check items Probable malfunction location Screen is not switched to camera image, when camera switch is pressed and when shift position is shifted to the reverse position. “AROUND VIEW MONITOR” is not displayed on the system selection screen of CONSULT. ...
Removal and Installation
CAUTION:
Never excessively pull body side welt.
Never damage the body panel.
REMOVAL
Front Body Side Welt
Pull the mounting part inside the vehicle to the outside of the vehicle, and then remove front body side welt.
CAUTION:
Remove the headlining portion of front body side welt slowly and carefu ...
Biometric cooling
Example
The Nissan Armada features an advanced Biometric Cooling system that utilizes
an infrared (IR) sensor to intelligently monitor passenger surface temperature and
automatically adjust airflow for enhanced comfort. This innovative technology allows
the Nissan Armada to dynamically ad ...