Chevrolet Sonic manuals
 

Nissan Armada 2025-2026 Service and Repair Manual: Symptom Table

Nissan Armada 2025-2026 Service and Repair Manual / Driver Information & Multimedia / Audio, Visual & Navigation System — Around View Monitor / Symptom Diagnosis / Symptom Table

AROUND VIEW MONITOR SYSTEM

Symptoms Check items Probable malfunction location
Screen is not switched to camera image, when camera switch is pressed and when shift position is shifted to the reverse position. “AROUND VIEW MONITOR” is not displayed on the system selection screen of CONSULT. Around view monitor control unit power supply circuit

Check that the following "DATA MONITOR" items operate normally using CONSULT

  • "CAMERA SWITCH SIGNAL"

  • "REVERSE SIGNAL"

 "CAMERA SWITCH SIGNAL" and "REVERSE SIGNAL" are normal Around view monitor control unit
"CAMERA SWITCH SIGNAL" or "REVERSE SIGNAL" is not normal CAN communication
Screen is switched when pressing camera switch or shifting selector lever to the reverse position, however, all views are not displayed. Only superimposing is displayed (only images that AV control unit plots are displayed). LVDS (between around view monitor control unit and each camera)
Superimposing is not displayed. AV control unit or LVDS (between around view monitor control unit and AV control unit)
The screen is not switched to the rear view image even if the selector is shifted to the reverse position. The front view is displayed normally. CAN communication (Reverse signal)

  • Front view screen is not displayed.

  • Front of top view screen is displayed.

Check the following "DATA MONITOR" items using CONSULT.

  • "F-CAMERA IMAGE SIGNAL"

  • "F-CAMERA COMM STATUS"

  • "F-CAMERA COMM LINE"

 NG LVDS (between front camera and around view monitor control unit)
OK Front camera

  • The rear view screen is not displayed.

  • Rear of top view screen is not displayed.

Check the following "DATA MONITOR" items using CONSULT.

  • "REAR CAMERA IMAGE SIGNAL"

  • "R-CAMERA COMM STATUS"

  • "R-CAMERA COMM LINE"

 NG LVDS (between rear camera and around view monitor control unit)
OK Rear camera

  • The side view screen is not displayed.

  • Left side of top view screen is not displayed.

Check the following "DATA MONITOR" items using CONSULT.

  • "Left camera image signal"

  • "Left camera comm status"

  • "Left camera line"

 NG LVDS (between side camera LH and around view monitor control unit)
OK Side camera LH
Right side of top view image is not displayed.

Check the following "DATA MONITOR" items using CONSULT.

  • "Right camera image signal"

  • "Right camera comm status"

  • "Right camera line"

 NG LVDS (between side camera RH and around view monitor control unit)
OK Side camera RH
Around View Monitor
...

Normal Operating Condition
...

Other materials:

NVH Troubleshooting Chart
Use chart below you find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference DRIVE SHAFT REAR AXLE Noise Shake Noise Shake Vibration Shimmy Judder Poor quality ride or Excessive joint angle × × — — — ...

PRECAUTIONS FOR REMOVING BATTERY TERMINAL : Precautions
NOTE: NOTE: NOTE: The removal of 12V battery may cause a DTC detection error. HOW TO DISCONNECT 12V BATTERY TERMINAL Disconnect 12V battery terminal according to instruction described below. Open the hood. Turn ignition switch to the ON position. Turn ignition switch to the OFF position with the d ...

Removal & Installation
WARNING: REMOVAL Remove engine cover. Refer to Removal and Installation. Disconnect battery cables from negative terminal. Refer to Removal and Installation. Remove engine under cover front and front under cover using a power tool (commercial service tool). Refer to Removal and Installation and Remo ...

© 2014-2026 Copyright www.niarmada.com
 
0.0069