Removal and Installation
REMOVAL
Remove front seat. Refer to Removal and Installation.
Disconnect seat belt buckle harness connector and disengage harness clip.
Remove seat belt buckle mounting anchor bolt, and then remove seat belt buckle.
INSTALLATION
Install in the reverse order of removal.
Inspection
AFTER A COLLISION
WARNING:
To avoid the risk of death or severe injury:
-
Inspect all seat belt system components including the seat belt webbing, retractors, pretensioners, buckles, anchors, and attaching hardware after any collision.
-
Inspect all seat belt assemblies and components including webbing, retractors, buckles, anchors and attaching hardware not in use during a collision. Replace if either damage or improper operation is noted.
-
Failure to follow any of the above steps could result in serious personal injury in an accident.
Replace any seat belt assembly (including anchor bolts) if:
-
The seat belt is in use at the time of a collision (except for minor collisions and the belts, retractors and buckles show no damage and continue to operate properly).
-
The seat belt is damaged in an accident (i.e. torn webbing, bent retractor or guide, etc.).
-
The seat belt attaching point is damaged in an accident. Inspect the seat belt attaching area for damage or distortion and repair if necessary before installing a new seat belt assembly.
-
Anchor bolts are deformed or worn out.
-
The seat belt assembly must be replaced even if the seat belts were not in use during the collision in which the air bags were deployed.
PRELIMINARY CHECKS
Check the seat belt warning lamp for proper operation. Refer to Seat Belt Warning Lamp.
If the air bag warning lamp turns ON, perform self-diagnosis using CONSULT. Refer to CONSULT Function.
Check that the seat belt retractor, seat belt anchor and buckle bolts are tightened firmly.
Repeat steps above if necessary to check the other seat belts.
Other materials
Differential Lock Indicator Lamp Flashes While Driving
Description
The differential lock indicator lamp will flash once every 2 seconds when the differential lock system is in standby condition. Standby condition is the time between when the differential lock mode switch is turned ON and when the differential lock control unit sees all conditions are me ...
Front Door Hinge
Removal and Installation
REMOVALRemove front door assembly. Refer to Removal and Installation.
Remove front door hinge mounting bolts, and then remove front door hinge.INSTALLATIONNote the following items, and then install in the reverse order of removal.CAUTION:
Before installation, check the fro ...
Preset Switch
Exploded View
Front center console switch finisher assembly
Preset switch
: N·m (kg-m, in-lb)
Removal & Installation
REMOVALRemove the front center console switch finisher assembly. Refer to Removal and Installation.
Remove the preset switch mounting screw , and remove ...