Exploded View
 |
Back door panel |  |
Tail lamp LH |  |
Grommet |
 |
Tail lamp RH | ||||
 |
: Clip | ||||
 |
: N·m (kg-m, in-lb) | ||||
Removal and Installation
CAUTION:
Disconnect the battery negative terminal or remove power circuit fuse when performing the operation for preventing electric leakage. Refer to Precautions for Removing Battery Terminal.
REMOVAL
Remove back door finisher. Refer to Removal and Installation.
Remove rear emblem and rear emblem bracket. Refer to Removal and Installation.
Disconnect tail lamp harness connectors 
.
Remove tail lamp mounting nuts .
Apply protective tapes (A) on the part to protect it from damage.
Disengage tail lamp RH fixing clip using a remover tool (A).
|
: Clip |
Disengage tail lamp RH fixing clip using a remover tool (A).
|
: Clip |
Remove grommet , and then remove tail lamp RH.
Apply protective tapes (A) on the part to protect it from damage.
Disengage tail lamp LH fixing clip using a remover tool (A).
|
: Clip |
Disengage tail lamp LH fixing clip using a remover tool (A).
|
: Clip |
Remove grommet , and then remove tail lamp LH.
INSTALLATION
Note the following item, and then install in the reverse order of removal.
CAUTION:
Visually check clips for deformation and damage during installation. Replace with new ones if necessary.
Replacement
CAUTION:
Disconnect the battery negative terminal or remove power circuit fuse when performing the operation for preventing electric leakage. Refer to Precautions for Removing Battery Terminal.
TAIL LAMP
CAUTION:
Replacement of a single part is not possible due to the adoption of LED. For replacement, replace tail lamp as a set. Refer to Removal and Installation.
Other materials
Precautions for Removing Battery Terminal
PRECAUTIONS FOR REMOVING BATTERY TERMINAL : Precautions
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.
NOTE:
Some ECUs operate for a certain fixed time ev ...
Normal Operating Condition
Description
Symptom Result
Brake pedal slightly vibrates and operation sound (motor sound and sound from suspension) occurs when VDC function, TCS function, ABS function, EBD function, brake limited slip differential (BLSD) function, brake assist function, hill start assist function, or advanced ...
Glass Lid Guide
Exploded View
Refer to Exploded View.
Removal and Installation
REMOVALRemove drain assembly. Refer to Removal and Installation.
Remove sunshade. Refer to Removal and Installation.
Remove side trim and glass lid guide from moonroof frame assembly.
Remove side trim from glass lid guide.INSTALLATIO ...