Exploded View
Refer to Exploded View.
Removal and Installation
REMOVAL
Remove front evaporator. Refer to Removal and Installation.
Disconnect sub harness connector
from intake sensor harness connector.

Remove intake sensor harness connector from front case upper.

Remove intake sensor from front evaporator.

CAUTION:
-
Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor can be located in the same position.
-
Never damage the evaporator core.
INSTALLATION
Note the following item, and then install in the reverse order of removal.
CAUTION:
Never rotate the bracket insertion part when removing and installing the intake sensor.
Other materials
Third Seat Belt Retractor
Removal and Installation
REMOVALSeat Belt Retractor (LH and RH)Remove third seat assembly. Refer to Removal and Installation.
Remove anchor plate mounting anchor bolt .
Remove shoulder anchor.Remove back pillar garnish. Refer to Removal and Installation. Remove shoulder anchor mounting anchor bolt ...
Back Door Window Glass
Exploded View
Back door outer panel
Back door window glass
Spacer A
Clip upper RH
Clip lower
Spacer B
Spacer C
Back door window glass molding
Dam sealant rubber
Clip upper LH
Glass primer
Adhesive
Adhesive mark
: Always replace after every disassembly.
...
Active Grille Shutter
Exploded View
With Flap
Active grille shutter
: Clip
Without Flap
Active grille shutter
: Clip
Removal and Installation
REMOVALRemove front combination lamp. Refer to Remova ...