Work Procedure
CHECK START
-
In the cool LED status (wait for more than 10 minutes after turning headlamp OFF), turn ON and turn OFF headlamp for the several times. Check that headlamp operates normally each time.
-
In the cool LED status, turn headlamp ON, wait until headlamp enters to the stable status (approximately 5 minutes after turning headlamp ON), and then check that headlamp operates normally without blinking or flickering.
-
In the warm LED status (turn headlamp ON for more than 15 minutes and wait for 1 minute after turning OFF), turn ON and turn OFF headlamp for the several times. Check that headlamp operates normally each time.
-
Turn headlamp ON for approximately 30 minutes, and then check that headlamp operates normally without difference in brightness between LH and RH, blinking or flickering.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Refer to Symptom Table.
Other materials
Rear Drive Shaft Boot
Exploded View
Circular clip
Dust shield
Housing
Snap ring
Ball cage/steel ball/inner race assembly
Stopper ring
Boot band
Boot
Shaft
Joint sub-assembly
: Wheel side
1: NISSAN genuine grease or an equivalent. ...
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger fo ...
Additional Service When Replacing Chassis Control Module
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the chassis control module. For details the operation, refer to “CONSULT Operation Manual”.
Work Procedure [After Replacing Chassis Control Module]
WRITING VEHICLE SPECIFICATION
With CONS ...