Description
Performing the following procedure can automatically activate recommunication of ECM and Intelligent Key unit, but only when the ECM is replaced with a new one*. For details, refer to Work Procedure.
*: New one means a virgin ECM that has never been energized on-board.
(In this step, initialization procedure using CONSULT is not necessary)
CAUTION:
When replacing the ECM, always replace it with a new one.
The functions controlled by the ECM does not operate properly in case of reuse of the ECM from another vehicle.
NOTE:
-
When the replaced ECM is not a brand new, the specified procedure (Initialization of Intelligent Key unit and registration of Intelligent Keys) using CONSULT is necessary.
-
If multiple keys are attached to the key holder, separate them before beginning work.
-
Distinguish keys with unregistered key IDs from those with registered IDs.
Work Procedure
PERFORM ECM RECOMMUNICATING FUNCTION
-
Install ECM.
-
Contact backside of the registered Intelligent Key* to push-button ignition switch while push switch is pressed, then turn ignition switch ON.
*: To perform this step, use the key that is used before performing ECM replacement.
-
Maintain ignition switch in the ON position for at least 5 seconds.
-
Ignition switch OFF.
-
Check that the engine starts.
>>
GO TO 2.
PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM
Refer to Description.
>>
END
Other materials
How to enable/disable the RCTA system
Vehicle information display
Steering-wheel-mounted controls (right side)
Follow these steps to activate or deactivate the Nissan Armada RCTA system:
1. Press the
button until the "Settings" menu appears in the vehicle information display, then
confirm using the scroll di ...
Front Drive Shaft
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
FRONT DRIVE SHAFT IN ...
Third Seat Reclining Switch
Removal and Installation
REMOVALRemove seat switch escutcheon. Refer to Removal and Installation.
Disengage fixing pawls and then remove third seat reclining switch.
: Pawl
INSTALLATIONInstall in the reverse order of removal. ...