Description
When the ignition switch is placed ON, the low tire pressure warning lamp blinks. And then 1 minute later, low tire pressure warning lamp turns ON.
Diagnosis Procedure
CHECK TIRE PRESSURE SENSOR INSTALLATION
Check visually that tire pressure sensors are installed to each wheels correctly.
NOTE:
In the following case, tire pressure monitoring system (TPMS) does not function.
-
Tire pressure sensor(s) are not installed.
-
Tire pressure sensor(s) of other cars are installed.
Are the genuine NISSAN tire pressure sensors are installed correctly?
YES>>GO TO 2.
NO>>Replace and/or Install tire pressure sensor(s).Refer to TIRE PRESSURE SENSOR : Removal & Installation. GO TO 3.
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
Perform self-diagnosis for "AIR PRESSURE MONITOR” of “BCM”.
Is DTC detected?
YES>>Perform DTC diagnosis procedure. Refer to DTC Index.
NO>>GO TO 4.
TIRE PRESSURE SENSOR ID REGISTRATION
Perform tire pressure sensor ID registration. Refer to Description.
Is tire pressure sensor ID registration completed?
YES>>Adjust the tire pressure for all wheels specified to the value. Refer to TIRE AIR PRESSURE : Service Data. INSPECTION END
NO>>Perform diagnosis procedure of “TIRE PRESSURE SENSOR ID REGISTRATION CANNOT BE COMPLETED”. Refer to Description.
CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for BCM power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>Repair or replace error-detected parts.
NO>>Replace BCM. Refer to Removal and Installation.
Other materials
Head Up Display (HUD)
Basic information
Example
Example
WARNING
In the Nissan Armada, improper adjustment of the HUD brightness or position
may obstruct the driver’s forward visibility through the windshield, increasing
the risk of accidents that could lead to serious injury or death.
Do not ...
Seat Buzzer
Removal and Installation
REMOVALDisengage seat buzzer harness fixing clip.
: Clip
Disconnect seat buzzer connector.
Remove seat buzzer.
INSTALLATIONInstall in the reverse order of removal. ...
Front Door Woofer
Removal & Installation
REMOVALRemove the front door finisher. Refer to Removal and Installation.
Disconnect front door woofer harness connector.
Remove the front door woofer mounting screws , and then remove the front door woofer .
INSTALLATIONInstallation is the reverse order of removal. ...