Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Moonroof Does Not Operate Properly

Description

Moonroof does not operate normally.

  • Moonroof Tilt UP/DOWN, OPEN/CLOSE does not operate.

  • Moonroof Tilt UP/DOWN, OPEN/CLOSE operation is slow.

  • Judder occurs during OPEN/CLOSE operation of moonroof.

Diagnosis Procedure

CHECK MOONROOF UNIT ASSEMBLY

Check the following items.

  • Damage, deformation or trapped foreign material of slide rail.

  • Insufficient application of grease to sliding section of slide rail. Refer to Removal and Installation.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace the malfunctioning parts.

CHECK MOONROOF MOTOR ASSEMBLY POWER SUPPLY AND GROUND CIRCUIT

Check moonroof motor assembly power supply and ground circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace the malfunctioning parts.

CHECK LIN COMMUNICATION CIRCUIT

Check LIN communication circuit. Refer to Diagnosis Procedure.

YES>>

GO TO 4.

NO>>

Repair or replace the malfunctioning parts.

CHECK MOONROOF SWITCH

Check moonroof switch. Refer to Component Function Check.

Is the inspection result normal?

YES>>

Replace moonroof motor assembly. Refer to Removal and Installation.

NO>>

Repair or replace the malfunctioning parts.

    Other materials

    Service Information for Electrical Incident
    Work Flow WORK FLOW STEP DESCRIPTION STEP 1 Get detailed information about the conditions and the environment when the incident occurred. The following are key pieces of information required to make a good analysis: WHAT vehicle Model, Engine, Transmission/Transaxle and the System (i.e. Ra ...

    Transfer Control Unit
    Exploded View Transfer control unit : N·m (kg-m, in-lb) Removal and Installation WARNING: Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking an ...

    Filament
    Inspection and Repair INSPECTIONWhen measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger. Attach probe circuit tester (in Volt range) to middle portion of each filament. If a filament is burned out, circuit tester registers ...