NVH Troubleshooting Chart
NVH Troubleshooting chart

Use the Chart Below to Help You Find the Cause of the Symptom
-
Locate the area where noise occurs.
-
Confirm the type of noise.
-
Specify the operating condition of the engine.
-
Check specified noise source.
If necessary, repair or replace these parts.
Location of noise Type of noise Operating condition of engine Source of noise Check item Reference page Before warm-up After warm-up When starting When idling When racing While driving Top of engine
Rocker cover
Cylinder headTicking or clicking C A — A B — Tappet noise Valve clearance Refer to Adjustment. Rattle C A — A B C Camshaft bearing noise Camshaft runout
Camshaft journal oil
clearanceRefer to Inspection. Crankshaft pulley
Cylinder block (Side of engine)
Oil panSlap or knock — A — B B — Piston pin noise Piston to piston pin oil clearance
Connecting rod bushing oil clearanceRefer to Inspection. Slap or rap A — — B B A Piston slap noise Piston to cylinder bore clearance
Piston ring side clearance
Piston ring end gap
Connecting rod bend and torsionRefer to Inspection. Knock A B C B B B Connecting rod bearing noise Connecting rod bushing oil clearance
Connecting rod bearing oil clearanceRefer to Inspection. Knock A B — A B C Main bearing noise Main bearing oil clearance
Crankshaft runoutRefer to Inspection. Front of engine
Timing chain caseTapping or ticking A A — B B B Timing chain and timing chain tensioner noise Timing chain cracks and wear
Timing chain tensioner operation-
Refer to Inspection.
-
Refer to Removal and Installation.
Front of engine Squeaking or fizzing A B — B — C Drive belt (Sticking or slipping) Drive belt deflection Refer to Inspection. Creaking A B A B A B Drive belt (Slipping) Idler pulley bearing operation Squall
CreakA B — B A B Water pump noise Water pump operation Refer to WATER PUMP : Inspection. A: Closely related B: Related C: Sometimes related —: Not related
-
Other materials
Additional Service When Replacing Control Valve & Tcm
Description
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
When replacing the ...
Excessive Operation Frequency
Description
VDC function, TCS function, ABS function, EBD function, brake limited slip differential (BLSD) function, brake assist function, hill start assist function, advanced hill descent control function (4WD models) and trailer sway control function operates in excessive operation frequency.
Dia ...
Camera Aiming Adjustment
Work Procedure
Always adjust the camera aiming after removing and installing or replacing the front camera unit.
Always adjust the camera aiming after removing and installing or replacing the windshield glass.
CAUTION:
Place the vehicle on level ground when the camera aiming adjustment is ope ...