NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Oil Filter

Nissan Armada 2025-2026 Service and Repair Manual / Maintenance. Maintenance Procedures / Engine Maintenance / Oil Filter

Removal and Installation

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

REMOVAL

CAUTION:

  • Oil filter is provided with relief valve. Use genuine NISSAN oil filter or equivalent.

  • Never get burned when engine and engine oil may be hot.

  • When removing, prepare a shop cloth to absorb any engine oil leakage or spillage.

  • Never allow engine oil to adhere to drive belt.

  • Completely wipe off any engine oil that adheres to engine and vehicle.

NOTE:

Remove engine under cover using a power tool (commercial service tool). Refer to Removal and Installation.

Using oil filter wrench [SST: KV10115801 (NI-38956)] , remove oil filter .

: Engine front

INSTALLATION

Remove foreign materials adhering to oil filter installation surface.

Apply engine oil to the oil seal contact surface of new oil filter.

Screw oil filter manually until it touches the installation surface, then tighten it by 2/3 turn . Or tighten to the specification.

Oil filter:
  : 17.7 N·m (1.8 kg-m, 13 ft-lb)

Inspection

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

INSPECTION AFTER INSTALLATION

Check the engine oil level. Refer to Inspection.

Start the engine, and check there is no leak of engine oil.

Stop the engine and wait for 10 minutes.

Check the engine oil level, and adjust the level. Refer to Inspection.

    Other materials

    Side Turn Signal Lamp
    Exploded View For exploded view of side turn signal lamp, refer to Exploded View. Removal and Installation CAUTION: Disconnect the battery negative terminal or remove power circuit fuse when performing the operation for preventing electric leakage. Refer to Precautions for Removing Battery Terminal. ...

    Normal Operating Condition
    Description Because of modified sine wave output, the AC 120V outlet may not operate normally for electric appliance of which electric power consumption is 150W or less. Electric appliances requiring a large amount of electric power consumption at startup (e.g., CRT-based TV, power tool) Measurin ...

    Additional Service When Replacing Driving Video Recorder Control Module
    Work Procedure DRIVING VIDEO RECORDER CONTROL MODULE REPLACEMENT Replace driving video recorder control module. Refer to Removal and Installation. >> GO TO 2. WRITING OF VIN DATA TO DRIVING VIDEO RECORDER CONTROL MODULE With CONSULT Ignition switch ON and wait at least 5 seconds. Select ...