NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Parting Seal

Nissan Armada 2025-2026 Service and Repair Manual / Body Exterior, Doors, Roof & Vehicle Security / Exterior / Parting Seal

Exploded View

Parting seal A Parting seal B Parting seal C

Double-sided tape

[t: 0.8 mm (0.031 in)]

Double-sided tape

[t: 2.5 mm (0.098 in)] 		   
: Clip
: vehicle front
: Always replace after every disassembly.

Removal and Installation

REMOVAL

CAUTION:

Never use a material for remover tool which could damage body side panel.

Fully open front door and rear door.

Apply a protective tape (A) on the parts to protect it from damage.

Cut double-sided tapes using a remover tool (A) and cutter (B), and then remove parting seal C.

CAUTION:

Remove double-sided tape remaining on parting seal and body side panel with a double-sided tape remover after removing parting seal C.

Remove parting seal B fixing clip .

Apply a protective tape (A) on the parts to protect it from damage.

Cut double-sided tape using a remover tool (A) and cutter (B), and then remove parting seal B.

CAUTION:

Remove double-sided tape remaining on parting seal and body side panel with a double-sided tape remover after removing parting seal B.

Disengage fixing clips and peel off double-sided tapes from vehicle body, and then remove parting seal A.

CAUTION:

Remove double-sided tape remaining on parting seal and body side panel with a double-sided tape remover after removing parting seal A.

: Clip

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:

  • Always replace double-sided tape with a new one, if parting seal is reused.

  • Degrease parting seal mounting surface of body side panel.

  • Paint grain or dust on mounting surface of parting seal may spoil exterior appearance if it remains. Clean the mounting surface and check that no paint grain or dust remains, before starting the operation.

  • Always replace clips with new ones, if parting seal is reused.

  • Never wash the vehicle within 24 hours after installing so as to keep adhesive.

NOTE:

Refer to the figure below for the double-sided tapes mounting position of parting seal A.

Body side panel Parting seal A

Double-sided tape

[t: 2.5 mm (0.098 in)]
Rib Edge of parting seal A Edge of Double-sided tape
: vehicle front
E : 420.0 mm (16.535 in)
F : 30.0 mm (1.181 in)

    Other materials

    System maintenance
    Example Basic information The two radar sensors A for the I-BSI system are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as snow, splashing water, mist or fog. The blocked condition ma ...

    Body Side Welt
    Removal and Installation CAUTION: Never excessively pull body side welt. Never damage the body panel. REMOVALFront Body Side WeltPull the mounting part inside the vehicle to the outside of the vehicle, and then remove front body side welt. CAUTION: Remove the headlining portion of front body ...

    Third Seat Rh Position Initialization
    Description Perform the third seat RH position initialization when the following conditions are performed. For details, refer to Work Procedure. Replacing third seat control unit RH. Replacing third seat RH. Manual function and folding function of third seat RH does not operate normally. Work Proce ...