NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Body Side Welt

Nissan Armada 2025-2026 Service and Repair Manual / Body Interior / Interior / Body Side Trim / Body Side Welt

Removal and Installation

CAUTION:

  • Never excessively pull body side welt.

  • Never damage the body panel.

REMOVAL

Front Body Side Welt

Pull the mounting part inside the vehicle to the outside of the vehicle, and then remove front body side welt.

CAUTION:

  • Remove the headlining portion of front body side welt slowly and carefully.

  • Be careful to bend or damage any part of the headlining while taking out the front body side welt.

Rear Body Side Welt

Pull the mounting part inside the vehicle to the outside of the vehicle, and then remove rear body side welt.

CAUTION:

  • Remove the headlining portion of rear body side welt slowly and carefully.

  • Be careful to bend or damage any part of the headlining while taking out the rear body side welt.

INSTALLATION

NOTE:

The parts (finisher, garnish, headlining, etc.) that into contact with the body side welt is describing as trim.

Align body side welt identification color and vehicle position mark , and then install body side welt to the vehicle.

  • Front body side welt

  • Rear body side welt

Install body side welt.

CAUTION:

Check that body side welt fits tightly in each corner.

Pull out the lip of body side welt from each trim and cover it.

  • When reusing the body side welt.

    Use fingers to flip the lip of body side welt caught in the trim as shown in the figure, and then install it with body side welt to cover the trims.

  • When the body side welt is new.
    1. Pull the tab sheet of body side welt toward to vehicle outside as shown in the figure, and then pull the string from lip of body side welt.

      NOTE:

      By pulling the string, easily flip the lip of body side welt and cover the lip of body side welt onto the trims.

    2. Pull out the string from all around the body side welt.

      NOTE:

      The string separate from body side welt, but it is normal.

After installation, check the condition of body side welt lip. Refer to Inspection.

Inspection

NOTE:

The parts (finisher, garnish, headlining, etc.) that into contact with the body side welt is describing as trim.

  • Check that the lip of body side welt covers onto each trim .

  • If the lip of body side welt does not cover onto each trim, operate installation step 3. Refer to Removal and Installation.
    Other materials

    Ecm
    Exploded View With ProPILOT Assist 2.1 ECM bracket ECM Bracket : vehicle front : N·m (kg-m, in-lb) Without ProPILOT Assist 2.1 ECM bracket ECM : vehicle front : N·m (kg-m, in-lb) Removal & Installation CAUTION: Perform ADDITIONAL SERVICE WHEN REPLACING ECM. Refe ...

    Rear Final Drive Assembly
    Exploded View Final drive mounting bracket Rear final drive assembly Upper stopper Lower stopper Washer     : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal and Installation WARNING: Jacking up or lift up the vehicle may the vehicle height to g ...

    Additional Service When Replacing Occupant Detection System Control Unit
    Description When replacing occupant detection system control unit or removing and installing passenger seat, always perform zero point reset so that occupant detection system is activated normally. Refer to Work Procedure. Work Procedure PERFORM ZERO POINT RESET Perform zero point reset. Refer to De ...