Exploded View
 |
Passenger door mirror control module |  |
Clip |  |
Front door panel |
| : vehicle front | |||||
Removal and Installation
REMOVAL
Remove front door finisher (passenger side). Refer to Removal & Installation.
Disconnect harness connector.
Disengage passenger door mirror control module fixing clips, and then remove passenger door mirror control module.
INSTALLATION
Install in the reverse order of removal.
Other materials
Precautions. General Precautions
Description
Observe the following precautions to ensure safe and proper servicing. These precautions are not described in each individual section.
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and ...
Rear Wheel Hub and Housing
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
MOUNTING INSPECTIONC ...
Engine Coolant
Inspection
LEVEL
Check if the reservoir tank engine coolant level is within the “MIN” to “MAX” when the engine is cool.
: MAX
: MIN
Adjust the engine coolant level if necessary.
WARNING:
Never remove reservoir tank cap when engine is hot.
CAUTION:
Refill Genuine NISSAN Long Lif ...