Inspection
InspectionDisassembly and Assembly
DISASSEMBLY
Remove door mirror assembly. Refer to Removal and Installation.
Remove door mirror cover. Refer to Removal and Installation.
Disconnect all terminals from harness connector .
NOTE:
Make a mark (short note, photo, etc.) of terminals layout, before disassembly.
Remove harness clip and v ...
Removal and Installation
REMOVAL
Remove spiral cable assembly. Refer to Removal and Installation.
Remove steering angle sensor from spiral cable.
INSTALLATION
Note the following, and install in the reverse order of removal.
When replacing the angle sensor , if the lock pin is installed, remove the lock pin after installing ...
RADIATOR : Inspection
Check radiator for mud or clogging. If necessary, clean radiator as per the following:
Be careful not to bend or damage radiator fins.
When radiator is cleaned without removal, remove all surrounding parts such as radiator cooling fan assembly and horns. Then tape harness and connectors to prevent w ...