Removal & Installation
REMOVAL
Remove transmission assembly, refer to the following:
-
2WD models: Refer to Removal and Installation.
-
4WD models: Refer to Removal and Installation.
Remove drive plate. Refer to Removal and Installation.
Remove rear oil seal with a suitable tool.
CAUTION:
Be careful not to damage crankshaft and cylinder block.
INSTALLATION
Install rear oil seal.
-
Install rear oil seal so that each seal lip is oriented as shown in the figure.
 |
: Oil seal lip |
 |
: Dust seal lip |
| : Engine inside | |
 |
: Engine outside |
-
Press in rear oil seal (1) to the position as shown in the figure.
|
: Cylinder block rear end face |
 |
: 0 - 0.5 mm (0 - 0.020 in) |
-
Using a suitable drift (A), press-fit until the height of rear oil seal is level with the mounting surface.
-
Suitable drift: outer diameter 100 mm (3.94 in), inner diameter 85 mm (3.35 in).
CAUTION:
-
Be careful not to damage crankshaft and cylinder block.
-
Press-fit straight and avoid causing burrs or tilting oil seal.
-
-
Install in the reverse order of removal after this step.
Other materials
Cockpit
Example
The cockpit of the Nissan Armada is thoughtfully designed to provide intuitive
control, comfort, and accessibility for the driver. Every switch, button, and control
element is positioned to enhance driving convenience and ensure that essential functions
are always within easy reac ...
Rear Final Drive: R240 (dl) Tools and Preparation
Preparation
Special Service Tools
The actual shapes of the TechMate tools may differ from those of the special service tools illustrated here.
Tool number
(TechMate No.)
Tool name Description
KV10122000
(NI-53383)
Side oil seal puller
Removing side oil seal
KV10123000
(NI-53384)
Side oil ...
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger fo ...