Description
The ID of the tire pressure sensor installed in each wheel cannot be registered in the tire pressure monitoring system. Inspect the tire pressure sensor or the tire pressure monitoring system circuit.
Diagnosis Procedure
CHECK TIRE PRESSURE SENSOR INSTALLATION
Check visually that tire pressure sensors are installed to each wheels correctly.
NOTE:
In the following case, tire pressure monitoring system (TPMS) does not function.
-
Tire pressure sensor(s) are not installed.
-
Tire pressure sensor(s) of other cars are installed.
Are the genuine NISSAN tire pressure sensors are installed correctly?
YES>>GO TO 2.
NO>>Replace and/or Install tire pressure sensor(s).Refer to TIRE PRESSURE SENSOR : Removal & Installation. GO TO 3.
CHECK TIRE PRESSURE SENSOR ACTIVATION TOOL
Check tire pressure sensor activation tool.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace the battery of tire pressure sensor activation tool or repair/replace the tire pressure sensor activation tool.
TIRE PRESSURE SENSOR ID REGISTRATION
Perform tire pressure sensor ID registration. Refer to Description.
CAUTION:
To perform ID registration, observe the following points:
-
Never register ID in a place where radio waves are interfered (e.g. radio tower).
-
Never register ID in a place close to Nissan Armada vehicles including TPMS.
Is tire pressure sensor ID registration completed?
YES>>INSPECTION END
NO>>GO TO 4.
CHECK TIRE PRESSURE SIGNAL
Change the work location and perform ID registration again.
NOTE:
Depending on the tire pressure sensor position*, a blind spot exists, and the tire pressure receiver gets a poor reception. If an ID registration is performed under this condition, the registration may not be completed. In such case, follow the instructions below to improve the radio wave receiving environment.
-
Rotate tire by 90°, 180°, or 270°. (This step is to change tire pressure sensor position.)
-
Open the door close to the tire of which ID registration is ongoing.
*: Radio wave reception condition depends on vehicle architecture (e.g. body harness layout, tire wheel design) or environment.
When ID registration is performed, which wheels do not react?
All wheels react and ID registration is possible.>>INSPECTION END
Only certain wheel(s) do not react.>>Replace applicable tire pressure sensor. Refer to TIRE PRESSURE SENSOR : Removal & Installation.
All wheels do not react.>>Replace the BCM. Refer to Removal and Installation.
Other materials
Tow Truck Towing
Tow Truck Towing
CAUTION:
To avoid the risk of minor injury or property damage : If the 12V battery has low or no voltage, the transmission cannot be shifted into neutral. To transport the vehicle, it must have all four wheels off the ground and placed on a flatbed or track system.
All applicabl ...
Noise, Vibration and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference
FRONT AXLE
Noise Shake Vibration Shimmy Judder Poor quality ride or handling
Improper installation, looseness
...
Combination Meter
Removal and Installation
CAUTION:
When replacing the combination meter, always replace it with a new one. The functions controlled by the combination meter does not operate properly in case of reuse of the combination meter from another vehicle.
Be sure to perform the configuration when replacin ...