Exploded View

![]() |
Transfer assembly | ![]() |
Rear oil seal | ||
![]() |
: vehicle front | ||||
![]() |
: Always replace after every disassembly. | ||||
![]() |
: Apply transfer fluid. | ||||
Removal and Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVAL
Remove the drain plug to drain the transfer fluid. Refer to Draining.
Remove the rear propeller shaft. Refer to Removal and Installation.
Remove the rear oil seal.
CAUTION:
Never damage rear case and output shaft.
INSTALLATION
Install rear oil seal with a drift (commercial service tool) until metal flange part
reach the surface of rear case
.

CAUTION:
-
Never reuse rear oil seal.
-
Apply transfer fluid onto circumference of oil seal.
-
When installing, never incline rear oil seal.
-
Never handle the oil seal inner periphery and oil seal lip.
Install the rear propeller shaft. Refer to Removal and Installation.
Fill with new transfer fluid. Refer to Refilling.
Inspection
INSPECTION AFTER INSTALLATION
Check fluid leakage and the fluid level. Refer to Inspection.
Other materials
Accelerator Control System. Accelerator Control System
Accelerator Control System
Exploded View
Accelerator pedal assembly
Accelerator pedal bracket
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
Removal and Installation
REMOVALCAUTION:
Never disassemble accelerator ped ...
How to Set Srt Code
SRT Set Driving Pattern
CAUTION:
Always drive the vehicle in safe manner according to traffic conditions and obey all traffic laws.*1: Depress the accelerator pedal until vehicle speed is 90 km/h (56 MPH), then release the accelerator pedal and keep it released for more than 10 seconds. Depress the ...
Precautions
Precautions for Removing Battery Terminal
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal� described below.
NOTE:
Some ECUs operate for a certain fixed time even after ignit ...



