Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation
CAUTION:
Perform work with 2 workers, because it is heavy weight.
Support back door with a proper material and use protective tape or shop cloth to protect back door and body from falling and damage when removing and installing back door stay.
REMOVAL
Support back door assembly with the proper material to prevent it from falling.
WARNING:
Injury may occur if back door assembly is not supported with a proper material when removing back door stay.
Remove metal clip 
located on connection between back door stay 
and stud ball 
using a remover tool (A) according to the numerical order 1→2 indicated by arrows as shown in the figure.
CAUTION:
2 workers are required to support back door.
Disengage back door stay from stud ball of back door stay lower bracket.
Repeat the same operation to disengage back door stay from stud ball of back door stay upper bracket, and then remove back door stay.
Remove back door stay upper bracket mounting bolts, and then remove back door stay upper bracket.
Remove back door stay lower bracket mounting bolts, and then remove back door stay lower bracket.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
After installation, apply anticorrosive around the bolts to prevent rust.
After adjusting, check the open/close operation. Refer to Inspection.
Back Door Stay
...
Disposal
CAUTION:
When performing disposal operation, wear the protective glasses and protective gloves.
Fix back door stay using a vise (C).
CAUTION:
When cutting a hole on back door stay, always cover a h ...
Other materials:
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
Rear Floor Front
WARNING:
Work after rear fender, outer rear sill reinforcement, outer rear wheelhouse, and inner rear wheelhouse are removed.
Remove the welding point for easier installation.
: Vehicle front : Drill φ6 mm (0.24 in) hole for the plug welding hole (ultra high strength steel). : Weld the parts onto ...
Diagnosis Procedure
CHECK SYMPTOM
Check the symptoms.
A stop/start indicator lamp turned on, and did an engine perform a stall at the time of restart from a stop/start system?
YES>>
GO TO 2.
NO>>
Refer to Symptom Table.
CHECK STOP/START PROHIBIT CAUSE
With CONSULT
Select “Stop/Star engine stall cause d ...
0.0058