REMOVAL
Remove cover. Refer to Removal and Installation.
Disconnect light & rain sensor harness connector.
Disengage light & rain sensor fixing pawls, and then peel off light & rain sensor.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
Never reuse light & rain sensor. Always replace it with a new one when it is removed.
Never use light & rain sensor that is dropped.
Before installation, wipe off silicon pad remaining on windshield glass surface and clean sensor installation portion of windshield glass.
Just before installation, remove sensor protective cover. Never touch silicon pad
after removal of sensor protective cover. And when installing light & rain sensor, never allow silicon pad to touch bracket and other parts.

Install light & rain sensor so that connector faces vehicle upward.
Compress lock spring portions
vertically to windshield glass surface and fully engage both ends of lock spring.

After installation, perform check light & rain sensor. Refer to Inspection.
Exploded View
InspectionHammering
Elongation of aluminum alloy during hammering will be greater than with steel plates. Therefore, a wooden or plastic hammer should be used with a softer blow to prevent stretching and work hardening of panels. Observe the following in case body filler is applied after hammering.
Apply wash primer a ...
Exploded View
Circular clip Dust shield Housing Snap ring Ball cage/steel ball/inner race assembly Stopper ring Boot band Boot Shaft Joint sub-assembly : Wheel side 1: NISSAN genuine grease or an equivalent. 2: Apply paste [service parts (440037S000)]. : Always replace after every disassembly. ...
Basic information
The Nissan Armada Traffic Sign Recognition (TSR) system is designed to enhance
driver awareness by identifying and displaying the most recently detected road signs,
particularly speed limits. Using the advanced multi-sensing front camera unit positioned
near the interior mirror, the Nissan ...