CAUTION:
TAIL LAMP/STOP LAMP
CAUTION:
Replacement of a single part is not possible due to the adoption of LED. For replacement, replace rear combination lamp as a set. Refer to Removal and Installation.
TAIL LAMP
CAUTION:
STOP LAMP
CAUTION:
REAR TURN SIGNAL LAMP
CAUTION:
BACK-UP LAMP
CAUTION:
REAR SIDE MARKER LAMP
CAUTION:
Removal and Installation
Tail LampFoam Repair
During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.
URETHANE FOAM APPLICATIONS
Use commercially available Urethane foam for sealant (foam material) repair ...
Removal and Installation
REMOVAL
Remove luggage side lower finisher LH. Refer to Removal and Installation.
Disconnect automatic back door control unit harness connector.
Remove automatic back door control unit mounting nuts , and then remove automatic back door control unit .
INSTALLATION
Install in the reverse order of r ...
Exploded View
REMOVAL
Brake caliper assembly : N·m (kg-m, ft-lb)
DISASSEMBLY
Cap Bleeder valve Cylinder body Sliding pin Sliding pin boot Bushing Torque member : Vehicle front : N·m (kg-m, in-lb) : Apply rubber grease. ...